Description
A201005-01F / A201005 Atari Amplifone Flyback Transformer New Aftermarket. 19″ and 25″ vector monitor EHT New. NOTE: After installing if you have an issue with your heater voltage then you likely may have to unwrap only one turn of the white wire from around the ferrite core.
Eric von Bastian (verified owner) –
Great replacement for my dead red.
Chris Mah (verified owner) –
It was a bit confusing because of the dummy pots but we got it installed and the unit works.
thank you
security0001 –
if you have any trouble or questions we are always happy to help if you contact us through the site.
Arcad Lab (verified owner) –
Good part. Only issue I had was the blue wire tied from the heater pin to ground. Not sure if it was a leftover of the transformer rebuild and it’s not mentioned in the instructions. The wire was right on the bottom so the transformer would not sit flat on the board. Still working on it and will update after install.
John Hopper (verified owner) –
Really nice part that when combined with a 6100 focus block
brought my amp back to life.
Great customer service as well!
Jared Bresee (verified owner) –
As always you get top customer service and this is the highest quality flyback that you can get on the market today! I actually got one here for a backup just in case. Great for the 6100 monitors obviously a lot of them are temperamental and they’re starting to push 50 years old now, so it’s good to have a flyback on hand.