Description
CR23 CRT Neck Board 10-pin Socket (MP1042). Used on many Arcade CRT monitor chassis. NOTE: On some applications you may have to drill out the center hold of the socket to allow the CRT neck pcb guide to go through otherwise the neck pcb won’t push on the CRT quite far enough.
AL ROSS (verified owner) –
THE CRT SOCKET WORKED – I NEEDED TO MAKE AN ADAPTER TO MY OLDER CRT TESTER & REJUVINATOR. I WAS ABLE TO USE THIS PART TO MAKE AN ADAPTER SOCKET FOR TESTING ARCADE CRT’S – BASED OFF OF THIS ALSO, THIS SOCKET WILL WORK AS INTENDED IN OEM /REPLACEMENT APPLICATIONS AS IT SEEMED BETTER CONSTRUCTED THAN FACTORY NECK BOARD SOCKETS I HAVE SEEN – GREAT QUALITY PRODUCT, FOR A LOW PRICE.
delusional29 (verified owner) –
It would be nice for the description to list what monitors this will work with. Had a tough time distinguishing which CR-23 socket I need to various arcade monitors. So I ordered all 3 to compare on my own.
Chris Pehl (verified owner) –
This socket is exactly what I needed to make a CR-28 adapter for my rejuvenator. The hole in the middle is larger than the other CR-23 socket so this fits right on an Electrohome G07-FBO without modifications.
Great build quality.