330uF 250V Nichicon 105c B+ Filter Capacitor

(13 customer reviews)

$6.75

330uF 250V Nichicon 105c B+ Filter Capacitor with 10mm lead spacing snap cap.  This Capacitor is 25mm x 30mm so its sized perfect for the nintendo switching power supplies.

682 in stock

Description

330uF 250V Nichicon 105c B+ Filter Capacitor with 10mm lead spacing snap cap.  This Capacitor is 25mm x 30mm so its sized perfect for the nintendo switching power supplies like PP-7B, PP-1200A and others, and can be used on Wells Gardner K4600 and K4700 series chassis and any other brands and models of arcade monitors that use this value of capacitor.

Additional information

Weight .125 lbs
Dimensions 1.375 × 1 × 1 in

13 reviews for 330uF 250V Nichicon 105c B+ Filter Capacitor

  1. geech (verified owner)

    Nice to have the smaller modern version on the board. You have to do a little modding to fit it on the k4600 chassis but it’s an easy fix.

  2. PatrickVerner (verified owner)

    Works prefect. Thanks.

  3. delusional29 (verified owner)

    Worked great along with the B+ pot (P1028) on my k4600. Make sure you order that pot as well since the original is glued in place on the k4600. You may have to bend the pins slightly open to fit it in the + and – holes on the PCB. I also put some hot glue around it to reinforce it. No issues.

  4. Jared Bresee (verified owner)

    What do you say it’s more compact an all-around way better for my K 4600. I don’t know if this will work for other boards but I love the fact that it’s smaller and more efficient.

  5. will_tooker (verified owner)

    Used one of these on a 13″ Sanwa PM1718; the pins needed a little finagling due to the holes on the PCB being a bit too wide, but it installed perfectly and works great!

  6. geech (verified owner)

    As others said, took a little finessing to get in but easy enough and it looks great afterward. Solid as always.

  7. m1interactive (verified owner)

    I would not have figured out the mounting of this without the video. It was really helpful. The hardest part was removing the old cap. My desoldering tool was not large enough to go over the old cap posts, so I cut them first then it worked fine.

  8. JAMES XAVIER (verified owner)

    Great quality as always! Thank you!!

  9. David Jones (verified owner)

    Installed on my K4600, it’s a snug fit after pinching legs with needle nose pliers but it works great. My monitor will be good for the next few decades!

  10. Scott (verified owner)

    Superb replacement for the factory cap. Be sure to watch the video on the site/YouTube if you haven’t done it before. Mounts in the factory location (just slightly different)

  11. Scott Caldwell (verified owner)

    Excellent replacement part for my troubled WG monitor. It’s correctly filtered again.

  12. Michael McMaster (verified owner)

    Wish I would have remembered to order this when I got the cap kit lol. Either way, it’s installed and works as intended.

  13. Jeffrey Scott Anselm (verified owner)

    Took a little adjusting to the legs to fit in the board but pretty easy to install.

Add a review

Your email address will not be published. Required fields are marked *